Era One BD 3-channel handheld transmitter - ON3EBDR01

The Nice ERA ON3EBD is a remote control for gates and automation systems. This remote control works on a frequency of 433.92 Mhz and uses a rolling code security system.

The ERA ON3EBD remote control allows you to operate and monitor gates and automation systems. Its bi-directional transmission capability allows you to check the status of the door, including whether it is open, closed, partially opened or in motion. This is achieved by pressing the button followed by pressing one of the 3 channels stored in the Remote control.

The LED on the Remote control will light up in different colours to indicate the status of the gate automation.

This unique model has three channels/keys for activating/controlling three different automation systems.

Remote control operates on a frequency of 433.92 Mhz and uses rolling code protection for added security.

Remote control is powered by a CR 2032 3-volt button cell battery, located in the battery compartment on the side of the Transmitter.

Please note that remote port status reading is only available on systems where the NICE OXI-BD receiver is installed.

Remote control has a protection rating of IP40 and is suitable for use with gates, blinds and alarm systems.

The package contains: ERA ON3EBD remote control, CR 2032 battery, programme manual, keychain lanyard, remote control holder and double-sided tape for fixing the holder.

To disable the remote port status and convert the remote control to a simple NICE ERA ON remote control with single transmission, follow these steps:

Press the (!) button three times in a row.

Press and hold the button of one of the three buttons you want to exclude from the bi-directional transmission function until the LED turns GREEN and stays lit. Release the button.

Now the Remote control has been converted to a single transmission.

You can restore the previous function (bi-directional transmitter) of the custom button/buttons by performing the same procedure as described above. The difference is that the LED at the end is not red and constantly lit, but is GREEN to confirm the conversion.