Cherubini Roll RX Ø 45 tubular motor

The Cherubini Roll RX tubular motor has a simple mechanical end adjustment and a built-in receiver. It is applicable for Axle/Shafts from 50 mm diameter and is available in 10 to 50 Nm, the speed of the tubular motor depends on the force, see overview below. A handy feature of this tubular motor is that you can switch it in parallel without the need for relays. The final adjustment of this motor is simple and reliable and can be adjusted using adjustment screws on the motor housing. The Motor can make a maximum of 25 revolutions, has no obstacle detection. You can operate the tubular motor by remote control or pulse switch. This motor is ideally suited for applications such as Roller shutters, blinds and Screens because of its reliability and ease of use. In terms of ease of installation, this Motor can be easily installed, making it suitable even for installers with limited experience.

- Supplied without motor support and adapter set
- tubular motor 230 V/50 Hz
- with integrated radio receiver 433 MHz
- in the forces 10 to 40 Nm with a speed of 17 rpm
- the 50 Nm motor is called a speed of 12 rpm
- adjustable motor head
- for standard Cherubini, Faac o Altron motor support
- when removing inserts suitable for Somfy support
- suitable for Roller shutters, Screen and (vertical) blinds
- the Handheld transmitter is easy to program
- simple and precise adjustment of the mechanical end positions
- motors can be connected in parallel
- fits in tubes with a minimum inner diameter of 50 mm
- capacity of the final adjustment 25 revolutions
- supplied as standard with a white cable, length 2.5 metres
- not suitable for continuous use

download the Cherubini Roll RX tubular motor manual here

Type Cherubini Roll RX Ø 45 tubular motors
- Roll RX Ø 45 10/17 R - 10 Nm - 17 rpm - length 646 mm
- Roll RX Ø 45 15/17 R - 15 Nm - 17 rpm - length 646 mm
- Roll RX Ø 45 25/17 R - 25 Nm - 17 rpm - length 646 mm
- Roll RX Ø 45 32/17 R - 32 Nm - 17 rpm - length 646 mm
- Roll RX Ø 45 40/17 R - 40 Nm - 17 rpm - length 646 mm
- Roll RX Ø 45 50/12 R - 50 Nm - 12 rpm - length 646 mm

Important notes
If you are using this Motor to replace a defective Altron tube motor, you should also order the correct adapter set with it. Also, the old Altron handheld transmitter will not work on this tube motor.